June 22, 2004
More Motorcycle Maintenance
I've begun POR-15'ing my gas tank in earnest today.
|
| How to seal the petcock holes |
There was some question in my mind (and I've found various references on the web) about how to seal the fuel petcock holes on the bottom of the tank. Most people have done elaborate setups involving using rubber seals on strips of aluminum, or rubber cement on metal or wood. I think those are a bit too much now.
I cut out two pieces of a Zip-Loc bag (one of the thicker freezer varieties), and used some silicon fish tank sealant to lock them down. I just made sure to put a liberal amount of silicon around all three holes (encircle both screw holes and the main valve hole) before putting the plastic down. I've gone through two treatments of the Marine Clean and they are holding up just fine, so unless the Metal Ready has some adverse reaction to silicon or plastic (seems unlikely), I should be just fine. Will have some pics of the finished Clean tomorrow or the next day, as well as some water shots (it's nasty nasty nasty red from fuel and rust).
| TrackBack







by reid
on March 06, 2011
by reid
on November 23, 2009